Bystronic is in the top tier of the 2D laser field. Both laser cutting machines have their own characteristics.
Bystronic's software is recognized as the best in the industry, both in terms of programming and machine operation. Flexible operation, there are some features very suitable for laser cutting machine. It is easy for newcomers to master.
Tongxiang's software is slightly cumbersome compared to Baichao, and it is not easy for newcomers to grasp, and it is difficult for them to get started.
Laser Bystronic's energy consumption is low, both laser gas and electricity consumption is lower than that of Tongxiang. The stability of the laser is a little worse than that of the pass-fast. As for the upstairs said power loss close to 2000W, that is an irresponsible statement. CO2 lasers according to the use of time there will be power loss, because of the aging of the lens, including the laser through the same loss, the laser through the fast may be relatively small loss! In addition, his so-called maintenance-free laser, I can only lol! Never seen maintenance-free machine tools. That is, the chopper does not care about the use of good maintenance is not cut vegetables! Not to mention the machine tool.
On the question of service charges, we have the equipment of the Tongxiang hundred ultra equipment, two charges are similar, do not laugh at the fifty steps. Tong fast hundred super equipment are used for five years, the cost of spare parts maintenance fee is about the same, Tong fast slightly more. But the hundred super after-sales comparison of the fast people to deal with. Through the fast people too cattle! I don't want to talk to them!
As for the management level of the two companies, I don't know, so I can't really comment. It's a European company, so it's pretty much the same! Switzerland and Germany should have a Germanic style. I think that the company is just as messy, and wherever there are people, there is a struggle for power!
The failure rate of Baichao is higher than that of Tongxiang, which is mainly due to many minor problems, and the stability of Tongxiang's equipment is good. Cutting quality is slightly better than the hundred super. 6mm plate cutting speed slightly faster. Baichao programming operation is more simple and fast. Each has its own advantages, depending on how you choose. All good equipment, depending on that more suitable for themselves