Jinan Jinghua Bangwei polyurethane foaming machine equipment Co., Ltd. production of polyurethane spraying machine, polyurea spraying machine equipment, beautiful appearance, high degree of self-control, the proportion is accurate, high-pressure full mixing, self-cleaning type, with a good spraying effect, high degree of atomization, the surface smoothness is high, the accessories of the service life of a long time, the maintenance of the cost of low and other characteristics.
Polyurethane foam machine mixing material spraying machine equipment product features:
1, set spraying and pouring as a whole, a wide range of uses;
2, spraying, pouring mixing ratio, uniform, greatly improving the quality of the product, saving more raw materials;
3, can adjust the feed ratio, suitable for a variety of production needs;
4, heating system Intelligent temperature control and indirect heating mode, solving the problem of uneven heating of raw materials and local high-temperature heating caused by the deterioration of raw materials due to heating;
5, small size, light weight, easy to move, suitable for on-site operation;
6, the equipment is simple to operate, do not need professional personnel can be constructed;
7, low failure rate, easy to maintain, save more time;
Polyurethane foaming machine precautions:
1, before using the barrel of water jacket to add water, winter when out of service in a timely manner to drain the water.
2, add material liquid, pay attention to A, B material do not add the wrong, in order to prevent damage to the machine, resulting in accidents.
3, pouring machine stop using must clean the gun, easy to use in the future.
Polyurethane foaming machine use:
1, the use of this product voltage is 380 volts, three-phase four-wire system, the user according to the pump in the specified direction to connect the power supply.
2, before use in the two storage barrel water jacket and storage tank with water, to not see the tube shall prevail.
3, pouring machine A, B material liquid supply, open the automatic feeding port cut-off door, open the automatic feeding switch, you can complete the automatic feeding program.
4, in the casting machine relay to set a certain time, and then open the trial material port cut-off door, open the automatic feeding switch, weighing out the weight of the material within the set time and the weight difference, adjust to balance to achieve the proportion needed for the work.
5, pouring time setting, according to the required amount and the flow of the machine to set the required working time, pouring time can be set between 0-99 .9 seconds, set to 1%.
6, after the pouring time is set, turn on the gas supply switch, pull the wrench switch to start pouring, it will stop automatically when it reaches the set working time, but it should supply gas automatically for 3-5 seconds to flush the residual material, turn off the wrench switch, and then the machine will stop automatically when it reaches the set working time. The residual material, close the wrench switch, rinse the gun head with water and gas to finish the work.