1, want to dismantle an electric fan, must first make sure to disconnect the power supply, so as to avoid electrocution accidents.
2, Emmett fan is mainly Phillips screws and hexagonal plum type screws, so prepare the screw tool components can be.
3, the fan will be the external mesh cover screws unscrewed, usually also be stuck by the buckle, this time do not break hard. Press the buckle of the mesh cover down, and then both hands can be hard to clap the sides of the mesh cover.
4, and then remove the fan blades, generally desktop fans only need to disassemble the fan blade mesh cover cleaning is good. Vertical fans also need to disassemble the fan foot plate, the foot plate at the bottom of the large screws loosened, and then remove the tube on the foot plate to complete the disassembly.
Fan cleaning method
1, prepare a non-linting rag.
2, prepare the detergent (other effective cleaners can also be).
3, water soaked rags and pour the right amount of detergent.
4, the rag to wring out the water, but not too dry, to ensure that it will not drip can.
5, normal wipe the fan as a whole, focusing on wiping the fan and fan cover such parts. Remove the fan cover when you need to remove the fixed clip, the clip is not fixed in the same way depending on the operation.
6, wipe the fan blades and fan blade cover in addition to the first one or two times the use of detergent, the back of the wash cloth directly after wiping until the fan surface without detergent residue. (Remember that the towel should not be too wet, in order to prevent damage to the internal accessories of the fan) 7, after wiping the fan a new look, you need to dry for a few minutes and then electrify the wind, the fan is clean and dry.
7, for cleaning fan blades, is also very simple. You can laundry detergent to clean, but do not use gasoline and other oily stain removers, because oily stain removers will cause corrosion of paint and plastic, damage to the appearance of the fan and even life. After cleaning, use a clean dry rag to dry all the parts, and then put it in a ventilated place to dry.