3DMAX rhombus model is as follows:
1, open 3DMAX, create a new part graphic, as follows.
2, select the drawing unit is mm, click OK, the following figure.
3, click Insert, click Mixing, select the outstretched item, the following figure.
4, define the sketching plane, the following figure.
5, draw the center line, in the center line of each of the four elephants to take a straight line, and let the line two two perpendicular to each other.
6, click the right mouse button, select the switch profile.
7, in the center of the position of a point, the following figure.
8, click on the right side of the "hook" symbol.
9, and enter the depth of the section, as shown below.
10, complete the half of the rhombus.
11, and then in the same way to draw the other side of the rhombus, you get a complete rhombus, as shown below.
12, to the rhombus coloring, as follows.
13, at this point you have successfully made a rhombus model, as shown below.