1.1, check the machine parts and electrical control box is good.
1.2, check the oil level of hydraulic oil, whether the oil storage is sufficient, start the motor to observe the axial piston valve oil is normal.
1.3, open the cooling water valve to connect the cooling water.
2, operation
2.1, mold loading: push the mold transfer mechanism to the highest position, the plastic mold is installed on the moving template, screw down the fixed template, correct the plastic mold upper mold and fixed template and screw tighten the screw, fasten the plastic mold lower mold on the moving template, run the mold transfer mechanism, check the correct position of the mold.
2.2, barrel heating: turn on the electrical control box electric switch, add plastic in the barrel, fully heated to melt the plastic.
2.3, injection operation: turn on the solenoid valve 8 so that the mold transfer mechanism to rise and plastic mold closed, turn on the solenoid valve 6 will be injected plunger pressed into the barrel for injection. After the injection is completed, turn on the solenoid valve 6 to press the injection plunger out of the barrel, turn on the solenoid valve 8 to make the mold shifting mechanism down, you can open the plastic mold demolding.
3, maintenance and repair
3.1, check whether the hydraulic oil storage oil is sufficient, should be supplemented in time when insufficient, the oil should always keep clean.
3.2, the lubrication point according to the provisions of the regular oil lubrication, regular cleaning oil filter. Keep clean around the machine, do not make the dirt into the oil tank.
3.3, the machine should be wiped clean of dirt after use, smooth surfaces should be oiled.
3.4, regular inspection of the electrical parts, remove dirt, oil dust, keep the electrical contacts clean, and often remove dirt and dust on the connector.