What is the use method of ultrasonic cleaning machine?

Ultrasonic cleaning equipment consists of an ultrasonic cleaning tank and an ultrasonic generator. The ultrasonic cleaning equipment, which is deeply loved by customers, uses the ultrasonic generator to generate high frequency and high voltage, which is transmitted to the transducer through the cable connection line, and uses the high frequency vibration to make the solvent in the cleaning tank be subjected to ultrasonic action to achieve the purpose of cleaning. The use of ultrasonic cleaning equipment generally has the following steps.

1. Install, add water, heat and add detergent.

According to the installation instructions of ultrasonic cleaning equipment, connect all kinds of lines and power sources between the electric control cabinet and the main engine, and install water supply pipes, drainage pipes and overflow discharge pipes. Add a proper amount of clean water to the cleaning tank, and the liquid level shall be subject to immersion cleaning. Then start the electric heating switch to adjust the water temperature to a suitable temperature. When the water temperature rises to a suitable temperature, the cleaning agent is added and fully dissolved.

Second, pretreatment and parts placement.

Ultrasonic cleaning equipment is mainly used to clean precision parts, and its ability to deal with mud is weak. Therefore, before the ultrasonic cleaning equipment is used for cleaning, it is necessary to simply clean the object to be cleaned, so as to prolong the service time of the cleaning liquid. The items to be cleaned should be evenly distributed and placed without overlapping.

III. Start, Stop and Overflow

When ultrasonic cleaning equipment is used normally, ultrasonic waves are emitted from three directions at the same time. Press the side ultrasonic to start, and the ultrasonic on both sides will start at the same time. Turn the adjustment knob to the right to the appropriate power, and the display screen will show the current working power value of the bottom ultrasonic wave. To stop the machine, first set the power knob to the low position, and then press it to stop the bottom ultrasonic. There is too much oil slick on the surface of the cleaning tank, so it is necessary to open the overflow device to discharge the oil slick.

Fourthly, the post-treatment after cleaning.

Rinse the clean parts with clean water, and then blow off the residual liquid on the parts with a dust gun and an air compressor. After repeated use, the cleaning agent can be stored in the water storage bucket, which can be recycled and reduce the cost.

According to the use of ultrasonic cleaning equipment, we can see that the widely acclaimed ultrasonic cleaning equipment is simple and easy to operate, so it is widely used in precision machining. Ultrasonic cleaning equipment not only saves people a lot of manual cleaning time and labor cost, but also makes cleaning very accurate and thorough because of its powerful ultrasonic fluid jet.