Laser marking machine role:
Laser marking machine, also known as laser marking machine, laser printing machine, refers to the computer under the control of the high-frequency galvanometer and focusing mirrors, so that the laser beam on the surface of the object according to the need to etch out the marking information symbols of the equipment.
Laser marking machine tutorial:
1, connect the external power supply.
2, open the equipment main control box main power switch, check the water flow, water temperature is normal.
3, start the computer and enter the optical laser marking system.
4, open the laser power master switch and Q drive power switch. (with control panel description) M1: FM laser control mode, applicable to the guide pillar, punching needle, template M2: without the first pulse suppression, less used
M3: according to the out of the light signal continuous output, applicable to the independent guide pillar on the seat T-on: mandatory out of the light, according to the set mode of the laser output T-off: lock off. (any mode not out off)
RUN: running state, according to the computer control signal output laser INNER: internal control mode (has been set, the switch should be pulled to this position)
Knob: adjust the frequency with (playing the white body with 200-5K, the range of 3K or so; playing the black body with 5-50K, the range of 14K or so)
5, when the laser power supply READY light, press the laser power RUN button to light up the laser krypton lamp (when the current display is 6.5A when adjusting the current for the black body of 12A or so, the white body of 10A or so)
6, open the main control box on the vibrating mirror power switch.
7, tune into the graphics, set the parameters.
8, adjust the focal length, infrared alignment marking position, start working. Flowchart: Turn on the external power supply → general power switch POWER to start the computer into the optical labeling system → laser power switch POWER and Q drive switch POWER (panel description schedule) → laser power supply READY light press RUN to the current 6.5A → adjust the current (black body 12A, white body 10A) → main control box vibration mirror power supply to open
Can only be introduced to this! Some of the detailed technical parameters can not be said, but you can consult the Wuhan Jiaxin laser