Shock Xiong injection molding machine maintenance department parts supply, injection molding machine nozzle flange, barrel screw, special decoder, injection rubber piston rod, size hinge edge, steel bushings, copper bushings, lubrication pumps, variable pumps, heating rings, temperature sensing wire, heating contactor, electronic boards, displays, computers and so on
Shock Xiong injection molding machine collection of the Chen Xiong The mature energy-saving injection molding machine production experience, coupled with the selection of high-efficiency and high-quality servo motor oil pump system, realizes the advantages of energy-saving and environmental protection, high response speed, high repeatability, reliability, durability, and serenity, and reaches the national level of energy-saving standards.
Zhende's injection molding machines are driven by highly efficient and powerful servo motors, so that the output of the hydraulic system of the injection molding machine corresponds to the power required for the operation of the machine, with no high-pressure throttling and overflow energy loss, and the power saving is up to 80% compared to the traditional hydraulic system, and the power saving can be further enhanced by cooperating with the electromagnetic heating coil.
As the machine to avoid generating unnecessary heat, the machine cooling water consumption can be reduced by 70% - 80%, and effectively reduce the oil temperature rise, reduce the number of oil changes, extend the service life of the hydraulic oil and hydraulic system accessories, greatly saving the investment in equipment.
Zhende injection molding machine clamping part of the special design, the guide column surface plated with hard chrome and increase the diameter, to ensure the durability, especially set up the central electric quantitative lubrication system, never wear and tear; template and hinge using high-strength spheroidal graphite casting, to ensure that the template is not easy to deformation; can be set up for multi-stage clamping speed and pressure control, and can be automatically set up for high-pressure clamping position; vibration of the thimble and the back of the needle speed and pressure can be adjusted, when the use of vibration of the thimble and pressure can be adjusted. The speed and pressure of the vibrating ejector and the back pin can be adjusted so that when the vibrating ejector is used, the ejector action can be performed again without pushing the pin back to the end point, thus saving the cycle time.
The glue injection part can be set to five levels of injection speed and injection capacity control, 99-step variable speed high torque hydraulic motor temperature control accuracy of up to ± 1 ℃; also equipped with a screw anti-cold start device, with a low-temperature alarm, to prevent damage to the screw when the temperature of the solvent is insufficient to prevent damage to the screw, and there is a reversing device, to prevent leakage of glue.
Zhende injection molding machine is also equipped with a high-performance precision oil filtration device, in the device under normal continuous operation, the oil level can reach to the U.S. Nnas8 standard (i.e., cleaner than the new hydraulic oil), to reduce the burden on the hydraulic system and maintenance, to extend the life of the hydraulic system; the overall low-noise operation of the machine, to ensure that the environment of the production workshop is quiet.
The clamping force of this series of injection molding machines are 80, 120, 150, 180, 220, 260, 320, 400, 480, 560 tons.