A, water washing machine:
1, need to often have hot water to rinse the soap box, to ensure that the soap box internal residue.
Phenomenon: soap into the outer cylinder is not smooth, the outer cylinder corrosion increased.
Reason: the buildup of soap residue, and some corrosive.
Solution: Rinse the soap tank with hot water to ensure that no residue remains in the soap tank.
Correct operation: Rinse the soap tank with hot water every day after the washing is completed.
2, manual oil pump refueling should be standardized operation
Phenomenon: bearing life is short.
Reason: may not be correctly regulated to add grease and use the oil pump.
Solution: Use 0# lithium grease or 3# lithium grease mixed with engine oil, and make sure to press the handle to the bottom every time you add oil to the pump.
Correct operation: According to the product instruction manual, correctly select the grease and standardize the use of the pump.
3, when washing the cloth, must remember: check whether there is debris in the cloth!
Phenomenon: scratches in the inner cylinder, scuffed fabrics, etc.
Cause: there are metal foreign objects in the washing machine spinning cage.
Solution: Remove the metal foreign objects in the rotating cage.
Correct operation: Before washing fabrics, always remember to clean out the debris trapped inside the clothes or the fish spines, bones and other debris inside the tablecloth, so as not to cause unnecessary quality accidents.
4, poor drainage, caused by machine damage.
Phenomenon: washing machine high off the vibration is big, serious, laundry inner tube rubbing door ring and other phenomena.
Reason: washing machine drainage pipe design and installation problems, or pipe drainage is not smooth. Directly affects the machine on the clothing for even and dehydration.
Solution: Thickening of the washing machine pipeline, or too many bends in the installation of the washing machine pipeline.
Correct operation: when installing the washing machine, the number of elbows installed should not exceed two; evacuate the drainage soft
pipes, should not be too long to avoid folding; when installing, do not block the pressure balance pipe.
5, the amount of clothing is too small, caused by machine accidents.
Phenomenon: washing machine shifting, door ring rubbing, in severe cases, the bearing seat, as well as bearings, seals damaged and other phenomena.
Reason: The amount of clothes loaded in the washing machine is below the low standard required for loading clothes, and the personnel at the laundry site are off duty.
Solution: Replace the bearings and seals, repair the washer door ring, and train and educate the washer operators.
Correct operation: the amount of clothes loaded in the washing machine is strictly in accordance with the requirements of the loading regulations, and when the washing machine is working, the laundry workers can not be off duty.
Second, the dryer:
1, the exhaust pipe installation is unreasonable caused by the dryer drying slow
Phenomenon: dryer drying slow.
Reason: in the installation of the dryer, the exhaust pipe design is unreasonable; from the dryer vent out to the laundry room on top of the exhaust duct set up between a number of bends, each bend is connected at right angles, so that the machine fan exhaust resistance is very large. Due to the right angle connection with the exhaust duct, so when other machines work will affect the machine's exhaust effect