Electronic control box, although small, but also according to electrical automation and other design regulations step by step to do.
One, familiar with the design of the task book. Grasp a few important information in the task book, if it is in a large project, the design task book will appear in the form of a technical annex to the contract. This relates to the advanced degree of control box and design and manufacture of cost control. Here does not pull the other, as long as the advanced degree of control on the line, which is related to your following selection and other work.
Second, according to the control requirements for programmatic design. If it is a larger project this can be upgraded to a feasibility study. Even if it is such a small box you should at least list no less than 2 kinds of program design, in the program design process, there should be a detailed calculation of the manual, so as to provide a basis for the design of your equipment, but also whether the design is reasonable, whether the key to science. Directly related to your manufacturing costs.
Third, the equipment design. After selecting the best program, we must carry out equipment design, this design phase, mainly equipment selection. Select the components in the following points should be noted: 1, to be able to achieve the design tasks required in the control function. 2, to ensure that a certain degree of sophistication of the equipment (in some of the technical annexes for the specific instructions), 3, to control the cost, do not blindly seek the most advanced and cause unnecessary cost waste.
After determining the need for a variety of components and equipment, it is necessary to carry out the design of the schematic diagram, the design of the schematic diagram should be based on their own program design and then combined with the selected electrical components of the electrical wiring principle.
Fourth, construction design. Here we do not pull the big engineering design steps and requirements, only the electronic control box. According to the size of the selected components, comprehensive consideration and selection of the specifications of the electronic control box (the country has a unified standard specifications of the electronic control box counter, there are non-standard, non-standard can be based on your choice of electrical components for the specification design).
After selecting or designing the specifications of the electronic control box, you can carry out the design of the box layout, which can refer to the relevant electrician process requirements. Because it involves more content will not be redundant, remember a few points on the line: 1, equipment components placed in a reasonable layout, to ensure equipment safety; 2, to facilitate construction, maintenance and so on.
The above is a specific drawing design process. The following is the procurement and installation and commissioning over.
One, according to the above equipment design, there will be a list of materials, according to the list of materials for the procurement of electrical equipment components. This will not cause a surplus of equipment waste, or equipment shortage phenomenon.
Second, according to the design of the construction drawings above, you can purchase the equipment back to the manufacturing department for installation and wiring. And carry out inspection and testing before the appearance.
Third, if your electronic control box has a programmable logic controller (PLC) and other automation equipment, you also need to design drawings after the completion of the program preparation, in the factory before a debugging. After arriving at the scene, but also according to the process requirements and then debugging.