How to use heparin pump of Braun dialysis machine

1) Installation of the whole machine: Make sure that the infusion pump is installed reliably, because the Bellon infusion pump is very heavy, about 3kg, and it is easy to topple when it is installed on a universal bracket. (2) Pipeline injection and exhaust. Bellon pump has no quick push/quick discharge function, and consumables need to be manually injected with liquid. Then close the liquid stop wheel of the infusion set. (3) electricity,

The power switch of Braun pump is an electronic switch on the front panel. When it is used in the operating room, it will not generate an arc and detonate the leaked anesthetic gas.

(4) Check the model of the infusion line.

Braun P infusion pump can use all kinds of Braun special tubes. Display and remind the operator to check the model of the selected infusion set every time it is turned on to ensure that it will not be misused by misoperation. This fully meets the requirements of special safety standards for infusion pumps.

Most infusion pumps in China use consumables to adapt to various pipelines in hospitals. Although it seems convenient for hospitals to use a variety of infusion sets as supporting consumables, it is little known that opening consumables is actually equivalent to opening risks. Belan has done a good job in this regard.

(5) Insert the infusion tube.

Press the door opener

B. Place the infusion tube: first put the infusion tube into the liquid stop clip, and then put the infusion tube down into the air sensor.

Close the pump door.

D. Open the liquid stop wheel of the infusion set to ensure that there is no dripping.

Place the droplet sensor.

(6) venipuncture.

(7) Set the infusion speed

Check whether the set value is consistent with the doctor's advice, and then press the "OK" soft key to ensure that no mistakes are made.

There is no "confirmation" step in the medical order input process of many infusion pumps in China, which has potential risks. Braun did a good job.

(8) Start infusion

Press the "Start" key, and the green operation indicator will light up.

(9) Stop infusion

Press the "Stop" key, and the green operation indicator will go out.

(10) shutdown

Press and hold the on key for more than 2 seconds, the power will be disconnected and the machine will prompt.

This soft shutdown ensures that the treatment opportunity will not be delayed because of the wrong shutdown. The hard switch on the back of the infusion pump is used as the power off, which may lead to the risk of wrong shutdown without prompt information.