Laptop water blue screen can still be repaired

Can a laptop be repaired if it has a watery blue screen

Yes.

As long as you are willing to spend money, any damage to the hard body can be repaired or replaced.

In general, after water ingress, you need to take out the point and a half, dismantle the machine and dry it.

If the boot is normal there is no problem, reproduction can not boot or blue screen to check the hard or soft body problems, and then for the problem to be solved.

The laptop into the water blew overnight boot blue screen so can still be repaired

can repair the laptop into the water treatment method 1. into the water do not be anxious and afraid to pull out the power immediately, take off the battery. (Remember, do not try to boot or plug in the battery power) 2. with a hair dryer to blow the keyboard surface, to move the blow, do not blow a little, or there may be a keyboard blowing bad, it will not pay off! 3. to send the machine to the repair store with a professional oven 80 degrees above the temperature of the baking for a few hours in the alcohol to clean up watermarks on the motherboard 4. with an external power supply to boot (remember to be an external power source, not the battery) 5. After the boot, look at the self-test process, such as self-test is too slow, immediately shut down, it is possible that the main board has been short-circuited, do not wait for 6. Such as self-test smoothly, then congratulations, the main components are not a problem, 7. Do not take chances with a hair dryer to blow the surface dry can be used in the boot bright or two or three days half a month a month machine may be some hard body hangs! The more you charge the machine the more serious the motherboard corrosion if you can come to the Nankai District, Anshan West Road, Yi Gao Digital Plaza, first floor a-142 easy repair easy repair is a national chain of almost every city has a store Baidu search easy repair in the bottom of the home page - service site query can be found to the national franchisee's address with the contact information

Laptop computer into the blue screen of the water can not turn on the machine how to solve the problem

The reasons for the boot of the blue screen are

Display card problems

Solution: (1) Reinstall the display card driver

(2) Re-plug the display card hardware

(3) Repair the display card hardware

Virus problems

Solution: Use the antivirus software to enter the safe mode to check the whole disk

System problems

The problem is that the system is not a good one. Solution: Check if there are any abnormalities in the boot items, if not, re-install the system

Hard disk problem

Solution: Check if there are any bad sectors in the hard disk.

Methods to recharge the system:

1, use other computer to download the tool to make pe boot tool (generally download universal pe5.0)

2, download the system image file

3, open the downloaded tool, select the one-click to make the creation of the u-disk pe boot boot tool, copy the image file on the u-disk

4, Use the U disk pe boot boot

5, format the system disk

6, use the image file to redo the system.

Notebook into the water, the motherboard burned can still repair

Notebook into the water, resulting in the motherboard burned, repair can certainly be repaired, but generally this cost will be a little big, may want to big hundreds or even thousands of dollars, not as much as add some money directly to a new laptop it, because after the repair, it is not likely to be as good as the previous

Notebook battery into the water can still be repaired

Batteries Can not repair the value, because the repair of the security risk is high, lithium batteries are not assembled, is going to start a fire, and the new battery is not too expensive, generally 200 yuan like, so do not have to repair, direct purchase of new, online such as Jingdong, Taobao, Tmall and so on a large.

Notebook into the water boot black screen special repair Notebook into the water how to do

Beijing Beiguang notebook repair company. Notebook repair using the most advanced fully automatic laptop motherboard welding device, you can weld any chip on the laptop motherboard, the welding of this device is characterized by: infrared temperature, weld uniformity, location accuracy, success rate of 95%. Can for notebook motherboard north bridge, south bridge, display card, PCI chip, network card, memory card slot, CPU base and so on all BGA package chip for arbitrary welding, not deformation. Laptop computer third-party chip-level repair service company. Repair motherboard failure phenomenon characteristics: 1, laptop computer does not start, boot no display, black screen, blue screen. 2, laptop computer password forgotten, can not enter the system. 3, laptop computer does not recognize the CD-ROM drive, hard disk, floppy drive, serial port, parallel port. 4. Laptop cannot install the operating system. 5. The laptop often goes down, loses power, or restarts automatically. 6, Laptop computer start-up error, can not enter the system. 7, Laptop battery can not be charged. Repair laptop computer LCD screen failure phenomenon characteristics: 1, boot display, LCD screen dark. 2, the external monitor is normal, the LCD screen. 2, the external monitor is normal, LCD white screen, screen. 3, there are bright lines on the LCD screen. Repair laptop computer keyboard failure phenomenon features: 1, the keyboard does not press the keys. 2, the keyboard key 3, the keyboard even. 2, the keyboard keys 3, the keyboard automatically press the keys. Repair laptop computer battery failure phenomenon characteristics: 1, the battery is not charging. 2, the battery can charge, discharge time is particularly short. Laptop motherboard repair, unlock the machine password laptop downtime power loss, the battery does not charge, can not find the CD-ROM drive laptop does not boot, do not recognize the hard disk, keyboard failure laptop LCD screen repair, splash screen, black screen, red screen, no display, bright line operating system installation, anti-virus, hard disk data recovery, hard disk repair full range of laptop motherboards, batteries, keyboards, CD-ROM drive LCD screen low-priced supply The treatment of computers after entering water Methods As you know, the same configuration of the laptop computer price is much higher than the desktop computer, and the laptop computer precision is not desktop computers can be compared, therefore, once into the water, the consequences are unimaginable. Light work is not normal, heavy, not yet had time to unplug the power supply will immediately cause a short circuit, burned components, so that the hard-earned savings of this book scrapped. Therefore, you can not let your lovely notebook stained with a drop of water (some people say this is not nonsense, stupid to do it). If you are not careful, really make the notebook into the water, no matter what kind of water (pure water, tea water, juice, drinks, etc., etc.), for the notebook such a sophisticated electrical appliances may be fatal. Remember, at this time, no matter what you are executing what program, no matter with whom you are chatting hot, should be immediately unplugged, remove the battery, can not use the normal shutdown, then it will be too late, immediately inverted the notebook, so that most of the water first out, and then look for some absorbent paper to the notebook outside of the water first dry, waiting to do further processing. Don't take a chance, think it doesn't matter, even if there is no problem now, then maybe one day the problem will come to your door, then, regret can be too late. Generally speaking, most of the parts of the advanced water is the keyboard, LCD screen into the water is not very likely. If there is too much water, it may flow down the keyboard to the motherboard. The next step is to find a suitable screwdriver and other tools, the notebook apart for further inspection. The structure of different models of notebooks are similar, first remove the keyboard, carefully observe, just screw a few screws on the line. After dismantling, you can see the motherboard, see the motherboard has no water, if water, you can first use absorbent paper to dry the water, and then use a medical cotton ball dipped in anhydrous alcohol (do not use the hospital panel puncture disinfection of the kind, the kind of water diluted 75%) gently wipe the circuit board, if one can not, you can repeatedly wipe 2-3 times. Never use water, because no matter what water it contains certain chemicals, over time, will corrode the motherboard, the same will make the notebook scrap.

My Samsung laptop motherboard is waterlogged, can it still be repaired?

You can try to repair, it is recommended that you find a good technology experienced personal repair business to help you try to repair, 90% can be repaired, notebook water, into the liquid do not re-power boot, the first time to unplug the power supply and the battery, and then find ways to dismantle the machine to clean and dry the water parts, generally all right, if there is still a problem, it is recommended that you find a good technology, experienced personal repair business to help you try to repair, basically can be repaired, but also can be repaired. Basically can be repaired. The notebook hard body doubtful answer

Notebook off the machine into the water can be repaired

can only recommend that you find a good technical personal repair master to help you try to repair, generally into the water did not power on, basically can be repaired, the notebook into the water, into the liquid do not re-power on, the first time to unplug the power supply and the battery, and then find ways to dismantle the machine to clean and dry the water parts, usually all right, if there is still the problem of the If you have a problem, we recommend that you find a good technical, experienced personal repair business to help you try to repair, basically can be repaired.

The first floor is loaded, as if it knows very well.

They said it was very clear, laptop, and you said "right"

For a normal shipping laptop, the problem with the blue screen is mostly the operating system. And what you're describing suggests that it's the File System that's the problem. (One question is, why are they still using a FAT32 File System when XP fully supports the much better NTFS?)

It is possible that a pirated version of XP, such as Tomato Home, may have ****ed off some of the features and services of the original XP, causing the system to become unstable, and causing a blue screen when running certain programs.

In the case of genuine XP, it is also possible that some patch packages were not installed successfully, resulting in compatibility issues between the system and the new hardware (here the new hardware refers to the hardware that appeared after the release of XP), which can also lead to blue screens.

So if you can't stand multiple blue screens, you can choose to reboot your system. However, it is recommended to install a genuine system (maybe the genuine one is not easy to get, it is easy to go for the OEM version, which is not much different from the genuine one) and update it to the latest. The driver should also be installed the latest, usually the brand's official website has a download link.

Finally, it should be noted that due to the popularity of Vista, XP has slowly started to be phased out, so many laptop manufacturers are not very enthusiastic about the problems that occur under XP when doing laptop testing, which means that maybe a machine is shipped, but it only meets the shipping requirements under Vista, but XP is not fully compliant (of course, he won't give you that). , later problems thrown to customer service, so people customer service is not good to do ah ^_^). So I suggest you install Vista, after all, this is the trend, do not always hold a XP.