1, before use to ensure that the gas flow
Before use, the upper end of the canister stem should be lifted up to ensure that the gas flow.
2, select the acupoints
Select the acupoints according to your condition, and when taking the acupoints, you can refer to the acupoints indicated in the acupoint taking chart.
3, select the appropriate position
Select the appropriate cans and comfortable position, can be divided into sitting, supine, lateral and prone position of these four.
4, different techniques for different conditions
According to different parts and conditions, different cupping techniques are used. Chinese medicine cupping can be used to stay in the can method (cans suction drawn in should be pulled out of the site after a certain period of time method), flash can method (cans suction drawn in the treatment site, the hand holding the cans quickly pulling the sound to not leave a mark is appropriate), walking can method (cans suction drawn in the cans, will be pulled from top to bottom repeatedly until the skin flushed) and piercing cupping method and so on a variety of methods. This is a very important part of the use of vacuum cupping device, but also the most skillful part.
5, adjust the negative pressure
The muzzle of the gun set on the upper end of the valve stem canister, vertically lifting the lever about 4 times, to achieve the appropriate negative pressure. Use the end of the can, the upper end of the valve stem gently lift the can body, canisters can be removed.
6, adjusted to the degree that the patient can tolerate
The negative pressure gun muzzle gently set on the top of the canister after the piston, vertical fast pull the rod several times, to the cupping of the skin within the skin bulge, the patient can tolerate the degree.
7, special parts can not be direct cupping
In the parts that can not be direct cupping (such as the spine, waist) can use the connector. Connector installation method: first connect the connector end of the connector rod big head to connect the spare front mouth of the big hole, and then the other end of the connector rod small head to connect the negative pressure muzzle, so that it becomes one, and then the front mouth and cupping cans with a piston at one end of the set together, and then cupping cans in the need to treat the parts.
8, clean up after use
Canisters after use, should be wiped with medical alcohol or disinfectant, can not be steamed, do not use safflower oil as a lubricant, in order to prevent damage to the canister.
What to pay attention to the operation of vacuum cupping device
1, cupping time can not be too long, otherwise it will cause harm to the body, generally about 15 minutes to remove the cupping.
2. When removing the can, pay attention to the technique, never forcefully pulling the can and pulling and turning. You should tilt the can to one side with one hand and press the skin with the other hand, so that the air can enter the can through the gap and then remove it.
3, cans pulled on do not move the position, in the use of multiple cupping therapy, cupping and cupping between the cans should be retained a certain distance, should not be arranged too close.
4, the local skin blisters, water droplets, bleeding spots, bruises and other phenomena are normal therapeutic reactions. Blisters light only need to prevent rubbing, to be absorbed naturally. When the blisters are large, it often suggests that the condition is more serious. The root of the blister can be punctured with a sterilized needle to release water, Oo to disinfected gauze to prevent infection.