How to install the red and blue line of Shanghai Sanshen portable high-pressure steam sterilization pot

1. First, confirm the correct connection of the power supply, turn on the power switch on the right side of the sterilizer, and then press the "POWERON/OFF" key to start the machine. When the pressure in the pot is confirmed to be , gently press down the handle of the sterilizer cover, unlock the pedal with the pedal, and open the cover; Fill the sterilizer with water (distilled water) until the water overflows the bar in the center hole of the chassis (about 2. liters of water is needed).

2. Secondly, put the articles to be sterilized, cover them until the magnetic seal is sealed, and lock the cover. Be careful not to be too full, and do not have individual small particles; Choose the operation mode (all choose the general sterilization mode, and ask the safety officer for instructions when choosing other modes); Start the sterilization procedure.

3. Finally, after sterilization, only when the temperature drops below 9 degrees (the pressure in the pot is ) can the lid be opened and the sterilized items be taken out; Press the "POWERON/OFF" key to disconnect the power supply.