Note: New disk, uninitialized, failed to initialize, "Specifies a non-existing device." appears. It's a bad contact or wiring problem with the hard disk.
It is the USB power supply is insufficient to cause the mobile hard disk can not start normally, the phenomenon of insufficient power supply may be present at the beginning, or may happen suddenly one day, this reason can not be specific judgment. It is also possible that the system settings, and possibly the mobile hard disk is faulty.
Solution:
1, one end of the SATA cable and power cable with the mechanical hard disk link, as shown in the figure below, the interface are anti-dumb design, relatively speaking, is still very convenient.
2. Open the chassis of the host, and open both sides of the chassis cover in order to find the corresponding line.
3, the host chassis, the power cord and SATA cable interfaces belong to different sides, so both need to be opened, in order to complete the installation.
4, finally, to find the hard drive chassis location, the hard disk into the best to be able to use the screws to fix, because the mechanical hard disk is very fragile, the collision will lead to the inability to use.
Expanded Information:
Hard disk made from an array of solid-state electronic memory chips, consisting of a control unit and a storage unit (FLASH chip, DRAM chip). Solid state hard disk in the interface specification and definition.
Functions and methods of use with the ordinary hard disk of the exact same, in the product shape and size is also completely consistent with the ordinary hard disk. It is widely used in military, automotive, industrial control, video surveillance, network monitoring, network terminals, power, medical, aviation, navigation equipment and other fields.