A, cardiac monitor manufacturers of different models of different methods of use, the steps are roughly:
1, connected to the power on
2, connected to the cardiac monitoring, usually using analog limb conduction (red, yellow, blue and black, that is, the right upper extremity, the left upper extremity, the left lower extremity, the right lower extremity) can be based on the patient's situation to choose the cardiac conductor even in the joints are marked with the corresponding English letters The corresponding letters of the alphabet are labeled on each connector.
3, connected to the oxygen probe, pay attention to the red light-emitting surface and nails close
4, connected to the cuff, adjust the time of blood pressure measurement
Two, the use of cardiac monitoring precautions:
1. Remove the cardiac lead wire, the lead wire plug convex surface of the front panel of the host of the "cardiac poor contact of the electrode sheet.
b. Fasten the electrode head of the ECG leadwire with the electrode buckle on the 5 electrode slices.
c. After the ethanol evaporates cleanly, the 5 electrode pieces are attached to the specific position after cleaning so that the contact is reliable and does not fall off.
d. Clip the lapel clips on the lead wires to the hospital bed to secure them. And instruct the patient and health care workers not to pull and tug the electrode wires and lead wires.
3. Be sure to connect the ground wire, which will play a very important role in the normal display of the waveform.