Regarding antimagnetic, electromagnetic compatibility EMC, is the ability of a device or system to operate in compliance with the requirements of its electromagnetic environment and not produce intolerable electromagnetic interference to any equipment in its environment. Therefore, EMC includes two aspects of the requirements: on the one hand, it refers to the equipment in the normal operation of the process of electromagnetic interference generated by the environment can not exceed a certain limit; on the other hand, it refers to the apparatus of the electromagnetic interference exists in the environment with a certain degree of immunity, i.e., electromagnetic sensitivity, so the best solution is the whole machine structural design and the use of environmental adjustments. The harm caused by static electricity on the equipment mainly shows the following phenomena: disk read and write failures, printer printing chaos, chip was pierced and even the motherboard was burned and so on. Industrial anti-static measures are as follows: 1, environmental hazard control; 2, process control; 3, grounding; 4, humidification; 5, anti-static additives; 6, static neutralizer; 7, to strengthen the management of static electricity safety.
On the moisture,
Humidity problem: the use of products in the environment, the humidity is too high, it will be condensed into water droplets on the motherboard, resulting in a short circuit of the motherboard.
Solution: Moisture-proof design or fully enclosed enclosure.
On the anti-glare irradiation, this is simple, if the equipment is used in the server room, the server room will be equipped with air conditioning and other equipment, there will be no such problems, if it is the open air, the computer is supposed to be a more sophisticated electronic products, you can do a good heat dissipation of the case of what fixed protection can be.