Brief introduction of wheelchair

GB/T1829 Wheelchair consists of the following parts:

-Part 1: Determination of static stability

-Part 2: Determination of dynamic stability of electric wheelchairs

-Part 3: Determination of brakes

-Part 4: Determination of energy consumption < Measurement of acceleration and deceleration

-Part 7: Measurement of seat and wheel dimensions

-Part 8: Static strength, Requirements and test methods for impact strength and fatigue strength

—— Part 9: Climatic test methods for electric wheelchairs —— Part 1: Determination of obstacle-surmounting ability of electric wheelchairs

—— Part 11: Test dummy

—— Part 13: Determination of friction coefficient of test surface

——— Part 14: Power and control of electric wheelchairs. Requirements for issuance and marking of documents

-Part 16: Requirements and test methods for flame retardancy of seat (backrest) pads

-Part 17: Interface of electric wheelchair controller

-Part 18: Up-and-down device-Part 19: Wheeled mobile device for motor vehicles

-Part 2: Standing wheelchair. Adjustment procedure

-Part 23: Requirements and test methods for stair climbing devices operated by caregivers

-Part 24: Requirements and test methods for stair climbing devices operated by passengers

-Part 25: Requirements and test methods for batteries and chargers

-Part 26: Terminology

This part is divided into GB/T 18.

this part is equivalent to iso 7176-7: 1998 wheelchair part 7: measurement method of seat and wheel dimensions (English version).

appendix a of this part is a normative appendix, and appendix b is an informative appendix.

this part was proposed by the people's Republic of China and the Ministry of civil affairs.

this part is under the jurisdiction of the national technical Committee for the standardization of rehabilitation and special equipment for the disabled (SAC/TC148).

The drafting unit of this part: National Rehabilitation Aids Research Center, National Rehabilitation Aids Quality Supervision and Inspection Center and Shanghai Hubang Medical Devices Co., Ltd..

The main drafters of this part are Yan Heping, Zhao Cishun and Gu Huiru.