Is the pickup table all wired and installed by yourself?

Taking table is not their own wiring installation. According to the installation instructions can be known to take the table is not their own wiring installation, the need for professional installers to install, installation steps: the pathology taking table to the designated location, carefully open the removal of packaging, do not touch, scratch the cabinet. Pay attention to safety when handling, will be wiped clean inside and outside the cabinet. Observe whether the power cord is exposed, plug in the power supply. Plug in the power cord, each button switch to "┃" for open, "O" for close. Check whether the instrument switch is sensitive. Check whether the equipment exhaust, lighting and water supply are normal. Operators should wear masks and gloves for operation. After use, close the exhaust air, lighting, disconnect the power supply. Pathology skimming table is equipped with a light switch, UV light switch, fan switch and pulverizer switch and 3 spare sockets, 1 pulverizer socket. Crusher switch control is the bottom of the cabinet within a crusher special socket (with logo) if the configuration of the crusher, the use of attention should be paid to: first open the water and then open the crusher; first shut down the crusher, 1min and then turn off the water; water heater needs to be filled with water and then energized, the socket is always charged, the water heater is not used in a timely manner should be turned off the switch, unplugged from the power cord. After each completion of the take, please use a dry rag to wipe clean. Once a week, use a damp cloth containing neutral detergent to remove dirt from the outer surface, and wipe it dry with a dry cloth. The skimmer table comes with an activated carbon filter. It is recommended that the filter be replaced every 3 months (depending on actual use). Caution: When turning on the UV lamp, be careful to avoid the UV lamp irradiation range to avoid being irradiated. In order to avoid certain dangers that may occur, all constructors must read the Instruction Manual carefully before operation. Avoid installing the cabinet in direct sunlight or near the heat generator. Avoid installing the cabinet near the return and outlet vents of the heating and cooling air conditioner and frequently opened doors and windows.