1. Inspection
Check all the connections, including the external power line is correct, whether the inlet and drain pipes are firmly connected.
2. Add liquid
Open the water inlet valve to the cleaning tank to add liquid, cleaning tank liquid level depth to the overflow port and keep the tank body has >40cm liquid. Equipment operation to diligently check the liquid level, there is a shortage of liquid to be supplemented at any time. Insufficient liquid level is strictly prohibited to open the heating, ultrasonic. The liquid can not contain strong acid, alkali and other corrosive ingredients.
3. heating
Open the main power switch. Set the cleaning temperature 55 ℃, press the "heating stop" can be.
4. Pre-treatment
before cleaning with a bamboo knife will be parts of the surface of the dirt (such as dust cover in its outer surface there will be a lot of dust, cylinder parts in the curve of the shell changes in its shell will be accumulated in a lot of thick and easy to remove the sludge) simple cleaning, in order to prolong the service life of the cleaning fluid. Ultrasonic can carry out precision cleaning, but its ability to deal with mud type of dirt is weak, so the pre-treatment, should try to remove the yellow mud or thin mud type of dirt.
5. Workpiece placement
Should try to make the workpiece evenly distributed, do not overlap. The workpiece should be gently put into the slot.
6. Cleaning
The material frame is placed. The temperature is within the set range; turn on the ultrasonic start switch for cleaning.
7. Remove
After the cleaning is completed, press "ultrasonic stop" to stop ultrasonic take out the workpiece, if there is secondary pollution need to be rinsed with drinking water.
8. Shutdown
Stop all functions after the completion of cleaning, and then turn off the power switch. When not in use for a long time should be released cleaning fluid, turn off the main power switch.
II. Precautions:The use of the process may cause harm to the operator and the equipment of the event
1. The equipment must be grounded according to the standard.
2. Do not use wet hands to operate the buttons, so that the cleaning fluid will not soak into the inside of the potentiometer, resulting in the machine does not work properly or damage to the equipment. Workpiece placement to the actual frame load shall prevail, not because of the increase in the number of cleaning and blind placement resulting in serious deformation of the frame, such as found in the connection position of the phenomenon of de-welding should be immediately patch welding treatment.
3. Parts cleaning on rubber, plastic and other raw materials made of accessories without significant aging effect, but the surface of the spraying of blending paint or parts of the paint can not be damaged, please be careful to put into the cleaning pool. Do not put parts that are not resistant to high temperatures and water intrusion (such as various sensors in the car) into the pool for cleaning.
4. Each time you add water, must be added to the level required (liquid depth & gt; 40cm); do not add boiling water directly into the cleaning tank), to prevent chain damage. Ultrasonic cleaning in the work never air agitation. Do not start ultrasonic and heating without liquid. Abnormalities in the operation process must be suspended, troubleshooting well before continuing to run the equipment.
5. Control cabinet should be placed in a ventilated dry location, such as accidental internal water, should be disconnected. Ensure that the dryness of no abnormalities before starting. Electrical damage to the equipment if replaced should be strictly in accordance with the electrical schematic wiring, do not change the wiring at will, the replacement of components is best to replace the same type of accessories.
6. No electrician operating license is not allowed to overhaul or move any component in the control cabinet.
Three, equipment maintenance
For the safety of operation and equipment life must be regularly checked
The main purpose of the equipment is to ensure the safety of the equipment.