Ice machine basic operation method and common sense?

Modernized business philosophy, efficient and orderly management mode for self-innovation. From 20kg to 60 tons per day, TIANCHI ice machines play an important role in the world's aquatic and meat processing, poultry slaughtering, catering, leather manufacturing, supermarkets, chemicals and dyestuffs, mines, concrete construction, medical equipment, ocean fishing, artificial ski resorts and other industries.

Always adhering to the "customer-oriented" business philosophy, strict control of the production process, and continuous innovation, in order to ensure that through a wide range of products, excellent quality, and trustworthy service to build a fine brand of ice machine.

Basic operation of the ice machine

(1) start

Open the water supply, the main power switch is placed in the ON (on) position, the machine began to work: the machine is equipped with a time-delay device, that is, after 3 minutes of power on to start the speed reducer, compressor and other components, during this period of time to indicate that the condensing temperature of the high red light (LED) flashes (i.e., a 3-minute time delay). The first batch of snowflake ice falls into the storage refrigerator about 3 minutes after the compressor starts, and the ice comes out normally after 10 minutes, producing hard ice.

(2) Shutdown

Turn off the main power switch and the machine stops working. Each time it is restarted, the machine starts to run automatically after a 3-minute delay.

(3)Indicator Description

The five indicator lights of the ice machine monitor the following situations:

Green light: the machine is in the power state;

Yellow light: the storage refrigerator is full of ice, when the ice is taken away 10 seconds, the machine automatically resumes work;

Yellow light: the water tank is short of water, when the water comes to the water after 10 seconds, the machine automatically resumes work;

Red light on: condenser temperature is too high or ambient temperature is too low;

Red light flashing: 3-minute delay state (normal) when power on;

Red light on: ice auger steering error or the speed is lower than 850.r.P.m;

Red light flashing: high temperature of the evaporator: i.e., evaporation temperature has not been reduced to below -1℃ even after powering on for 10 minutes;

Note:

1. Reasons for high condenser temperature: fan does not work; condenser clogging; condensing temperature sensor or P.C board damage Z ambient temperature is too high.

2. Reasons for high evaporator temperature: shortage of refrigerant; condensing temperature is too high; evaporator temperature sensor or P.C board is damaged.

(4) reset Ken instructions

When the machine stops working due to the activation of the safety device, such as restarting the machine need to determine the cause of the problem and troubleshooting, and then press the reset button (RESET) or put the main power switch in the OFF (off) position and then in the ON (on) position.