The feeder should be installed on a fixed foundation according to the specified installation method. Mobile feeder should be before the official operation of the wheel with a triangle wood wedge or brake. In order to avoid walking in the work, there are more than one feeder parallel operation, machine to machine, machine and wall should be one meter between the channel.
Feeder use before checking the operating parts, tape buckle and load bearing device is normal, whether the protective equipment is complete. The tension of the tape shall be adjusted to a suitable degree before starting.
The belt feeder should be started without load. Wait for normal operation before feeding. It is prohibited to feed first and then drive.
When there are several feeders running in series, they should start from the discharge end and start in sequence. All normal operation before feeding.
When there is a deviation of the tape during the operation, it should be stopped and adjusted, and should not be used reluctantly, so as not to wear out the edge and increase the load.
The temperature of the working environment and the materials to be delivered shall not be higher than 50℃ and lower than -10℃. It shall not convey materials with acidic and alkaline oil and organic solvent.
Pedestrians or passengers are not allowed on the conveyor belt.
Before stopping, the feeding must be stopped first, and only when the material stored on the belt is discharged can it be stopped.
The feeder motor must be well insulated. Mobile feeder cable do not pull and drag. The motor should be reliably grounded.
When the belt slips, it is forbidden to pull the belt by hand to avoid accidents.