Operation flow of Tianshan visual positioning machine

Inspection and acceptance process of visual inspection equipment: one key on/off, lighting button, three emergency stops, etc. This paper introduces the position of light source controller and main cabinet, including vibrating disk, direct vibration and ring vibration, direct vibration controller and ring vibration controller, and how to debug the controller (voltage and frequency). The process from circular vibration feeding to direct vibration feeding to glass plate, through thumbwheel A and thumbwheel B, to camera detection, and judging whether the sample is good or bad through software analysis after the camera takes pictures. If there is an undetermined sample, it will go directly to the undetermined air outlet. Matters needing attention in modulating direct vibration, the interval between direct vibration and glass plate, and the interval between dial wheels A and B and glass plate. The function of photoelectric sensor and how to trigger it, the charging standard of Shaoguan visual inspection equipment will only trigger if it is lower than 50. When wiping the glass plate, be careful not to press the glass plate hard, and wipe it with a dust-free cloth dipped in alcohol. If the glass plate is uneven, you can manually press the two places where the glass plate is buckled (pay attention to pressing the glass plate) until the glass is flat. After that, the baffle can't scrape the glass at an undetermined position, and the distance from the glass is less than the thickness of four layers of A4 paper. Alarm light, bright green when running, bright red when alarming. If the air pressure is low or the glass plate is stuck, the equipment will stop automatically. The visual inspection equipment needs to be cleaned regularly, and the lens should be wiped regularly with a dust-free cloth.