Activate the new battery to give the battery a good start. At present, many notebook computers are activated, which means that when the new notebook is turned on for the first time, the battery should be charged with 3% electricity (which is generally introduced in the manufacturer's manual). At this time, you should use the external power supply first, and then use the external power supply to charge the battery until it is turned off. When you go home, you should use up the battery before recharging it. The charging time must exceed 12 hours, and the battery should be activated three times repeatedly to lay a good foundation for future use.
Minimize the number of times you use the battery. As we all know, the number of charge and discharge times of a battery is directly related to its life. Every time the battery is charged and discharged, it will consume a small part of its life. This truth should be clear to everyone. For example, the newly bought mobile phone can be used for a long time after being fully charged, but after using it for a period of time, it will be found that the use time is obviously not as long as it was at the beginning, which is also the same reason. Therefore, we suggest that you plug in an external power supply as much as possible if you have it, so as not to affect your notebook.
Matters needing attention in using computer
1, to ensure that the computer has a good working environment, working temperature 10-35 degrees Celsius, humidity between 30-80%, AC voltage around 220V V, pay attention to heat dissipation and ventilation in summer, and avoid using the computer at high temperature for a long time; Pay attention to antifreeze in winter, and computers are actually very afraid of cold; Computers that are not often used should be turned on in wet season, otherwise the computers will be damaged due to humidity.
2. Using a three-pin power socket with overload protection can effectively reduce static electricity. If the hand can feel static electricity, use a wire with plastic outside and copper inside. One end is connected to the back plate of the chassis, and the other end is connected to iron conductors, such as water pipes and heating pipes. It's best to bury it underground if possible.
Frequent switching is harmful to the life of the computer. If the computer is turned on for a long time, it will accelerate the aging of the computer. When it is not used temporarily, it is used for screen protection, server or hibernation 10 hour, and it is best to turn it off 10-20 minutes before turning it on. Don't play computer all night, which is bad for the service life of computer and harmful to health.