1. The steel puller stands on the steel drawing platform, always paying attention to the black undulating molten steel level covered by mold flux, and twisting the potentiometer back and forth with his left hand from time to time to adjust the height of molten steel in the mold.
He is holding a small shovel with a long handle and a round bottom in his right hand, constantly scooping out black protective slag from the iron bucket next to him and adding a spoonful to the crystallizer. In the gap between adding flux, he has to change the casing and salvage slag.
Extended data:
1. Steel workers should wear complete labor protection articles before taking up their posts. When the insulating plate of tundish is oily or wet, steel shall not be poured. When the water seepage of crystallizer or upper opening is serious, steel shall not be poured.
2, steel drawing workers in the process of pouring steel, must wear protective glasses, shoes cover. When dismantling radioactive sources, you must wear protective clothing and a radiation detector. When cleaning the platform, it is forbidden to throw anything under the platform. Pay attention to safety when going up and down the ladder when loading and unloading the hydraulic cylinder, and be careful of oxygen tempering and burns when burning the big bag. It is forbidden to wear oily gloves and hold the joint between rubber hose and oxygen burning pipe. The length of oxygen pipe shall not be less than1500mm.
3. When lifting the slag bucket and movable cover plate, check whether the spreader is hung firmly and do a good job in safety protection. Wear protective gloves and safety shoes to prevent hands and feet from being scratched. When replacing crystallizer, use interphone to command crown block. When lifting the tundish, the chain should be hung firmly and both sides should be confirmed. It is forbidden to hang and impact the ladle roaster. Take a sample and be careful of burns.
Safety management network-responsibilities of sawing workers