1, this wifi is the hospital LAN, and does not connect to the Internet, so you can not get on.
2, wifi router or AP has been overloaded, you just connect, but can not get on the Internet.
3, the hospital did MAC binding, only the binding device can go to the Internet, not binding is not.
Methods to enhance the wifi signal:
1. First, enter the "router settings interface", and then open the "wifi settings".
2, in the "wifi" settings interface to find the "signal strength", the default signal strength to "through the wall mode", there is no "through the wall mode". Change the default signal strength to "Through Wall Mode", or "Strong" for "Through Wall Mode".
3. Pay attention to the direction of the antenna of the router, you can put the antenna vertically or a vertical and a horizontal and other angle direction combination.
4, pay attention to the installation position of the router, placed in the center of the area to be covered is good.