1. Get ready to install camera accessories, including pliers, screwdriver, camera, camera charger, camera bracket, chassis and BNC connector, and connect the BNC cable
2. Pick up the camera bracket. Install the chassis on the bracket
3. Install the camera on the bracket
4. Check whether the power supply is the power supply for the camera
5. Connect the power plug and the camera plug
6. Take the BNC cable out of the head and cut out the middle copper wire
7. Take out the BNC interface. Next, screw down
8 with a screwdriver, fix
9 with pliers, and connect the camera at the same time as the computer host or the camera hard disk to complete the installation.
Extended information:
1. Location requirements: For the surveillance camera, the location is directly related to the imaging effect of the equipment. Therefore, many users regard the monitoring effect as the primary reference for monitoring the camera installation position.
2. Installation angle: mainly divided into two types: cylindrical type and hemispherical type. Among them, the cylinder type is more common, and it is universal indoors and outdoors; Hemispherical type is generally used indoors, with small volume, and can be installed on the wall or ceiling. Direct light sources should be avoided, and it is best not to install against the light. Outdoor special supports should be selected as far as possible, but the wind resistance coefficient is quite different.
3. Installation height: The installation height of the surveillance camera should not be too low or too high, which is inconvenient for future maintenance. It is recommended that the installation height be three or four meters.