1. Laboratory water purifier placement
In the installation of the two points to note, first of all, according to the needs of the laboratory to select the appropriate pure water equipment, and secondly in the selection of laboratory water purifier placement should be noted that the placement of the location must be to ensure that the dry, horizontal no tilt, direct sunlight can not be, the device should be as close as possible to the drain and power supply, the placement of the location temperature should be Always keep the temperature above freezing point.
2. Installation of the bypass valve
After placing the laboratory water purifier in the selected location, you need to connect the bypass valve. However, before you start, you need to turn off the water line switch. In addition, drain the residual water from the water line pipes in your lab by opening all the faucets. One thing to note is that the bypass valve is very important for pure water equipment to ensure that the water supply is cut off at some necessary time.
3. Water supply link
When connecting the water supply of the laboratory water purifier, you can choose the hose or hard pipe, the advantage of the hose is flexible method, but the hose is easy to be damaged, the advantage of the hard pipe is safe, and the hard pipe leakage rate is less.
4. Connect the drain
Any water purification equipment needs a place to drain water, and it is no different for laboratory water purifiers. You can choose one of a variety of options, such as a floor drain, standpipe or utility sink. However, the most commonly used is a utility sink, and it is important to note that the drain is made of a relatively soft material, so it is important to make sure that the connections are secure when installing it to avoid leaks.
5. Start the system
After completing all the above steps, you can carry out the pure water production, but need to pay attention to a point, re-open the water supply switch is recommended to proceed slowly, to avoid a sudden increase in pressure and damage to fittings.
Finally just installed laboratory water purifier may wish to operate a few more times to test whether there are any problems.