How to reserve water purifier when installing plumbing?

Generally speaking, the water purifier is installed under the cabinet, so from the cabinet side, to consider the location of the water purification products, in order to design the storage space ; to determine the location of the installation of water purifier products, in order to reserve the location of the plumbing and electrical openings, to prevent rework of the cabinet. Some water purifiers, such as water softeners, are required to be connected to the power supply.

If you don't consider the installation location of the water purifier in relation to the installation location of the water purifier beforehand, there may not be enough number of sockets, sockets are blocked or the line is not long enough. So installing a water purifier is best to install a water purifier in the new house renovation, can be based on the overall consideration, will not appear these problems.

Points to note for plumbing and electrical installation

1, do not destroy the original electrical plumbing or plumbing piping when slotting and drilling. Electrical pipeline laying to wear wire pipe, do not bury the wire directly into the ground or wall, this is not only unsafe, and once damaged can not be repaired. Plumbing pipes must be laid after the pressure test, qualified and then do the next procedure to prevent damage caused by leakage of pipes.

2, water inlet should be equipped with indoor master valve, before installation must check the water pipe and connecting fittings are broken, sand, cracks and other phenomena.

3, the water meter installation location should be easy to read, water meter, valve distance from the wall should be appropriate, to facilitate the use and maintenance.

4, the kitchen, such as the addition of water softeners, water purifiers, KitchenAid, etc. should be considered in advance to leave a good location for the upper and lower water supply and power location.

5, cold and hot water pipes are into the wall practice, grooving needs to check the depth of the groove, hot and cold water pipes can not be the same groove.