The NJTD wiring harness is divided into positive and negative. So when you encounter insertion difficulties, you should adjust the insertion direction of the terminals in a timely manner, do not press hard into the normal insertion will hear a slight snap, after hearing the sound, do not make another effort, and should be pulled back to see if there is no trace of loosening.
Nanjing far drive wiring harness assembly method
The production of wiring harness sub-material number must be compared to the positioning board to determine the size of the cut line, in the current wiring harness assembly process, often can meet the sub-material number of the size of the size of the board can not be met, resulting in a lot of unnecessary waste sub-material number to the same electrical testing and full inspection, wiring of the wiring harness will be Each sub-material number in accordance with the requirements of the drawing laid flat on the positioning plate.
In the wiring first of all to a region to put a region, a single region of the sub-material number put after the sub-material number and then go to put the cross-region sub-material number, cross-region sub-material number should also be the first to put a simple and then put the complexity of the part of the insertion of PIN PIN TER must be inserted into the corresponding connectors, binding wire binding position according to the positioning board binding line starting point is generally in the positioning board in the starting position of the double line.