Homemade humidifier super simple new skills get up!

We all know that now on the net or in the mall or, the sale of humidifier products is very much, and the brand is uneven, it is difficult to distinguish good and bad. At this time if you can make a humidifier, then with a lot of peace of mind. Today to learn some homemade humidifier method, super simple oh.

Homemade humidifier method a

Required materials: ultrasonic atomizer is the most important part of the homemade air humidifier, the market production of ultrasonic atomizers on the business in particular, but the most readily available, it is necessary to count the decorative lamps used in the atomization of the movement. The power of this movement is generally 24W, the amount of atomization in about 300cc/har within, so the use of water mist produced may be slightly lower than the finished product sold on the market. After buying the movement do not think finished, we also need a humidifier with a water container. Since the humidifier produces water mist usually near the sleeping area, the atomizer movement should not be too far away from the sleeping area, in other words, we can not choose a container that is too deep. Therefore, it is recommended to use one with a larger opening, and if you have a small plastic basin at home you can avoid purchasing one.

Step by step: we connect the nebulizer and transformer, put the nebulizer in a nice tray with water, the water must not exceed the nebulizer to avoid dry burning. This atomizing head put into the water, will spray water upwards, in the box of the atomizer there is a set of plastic bracket, this bracket is used to place a water-blocking glass or plastic sheet on top of the humidifier to prevent splashing during the humidification process.

Homemade humidifier method two

Steps:

1, the outer box is a supermarket household cleaning box.

2, ultrasonic nebulizer head 25 mm more than 30 yuan a (can be loaded according to the need for 25).

3, the fan is a computer CPU fan (about 5 yuan) two can be.

4, the transformer of the atomizer head (power 5080 watts) one.

5, the fan transformer is a DC.

6, pvc pipe root can be needed. A little knowledge of electricity can be assembled. In addition, you can install a timer on the plug, set the start and stop time, from 9:00 a.m. to 9:00 p.m., every boot half an hour to stop fifteen minutes, twelve hours in the water consumption of more than six liters, the effect is not bad.

Finally must be a friendly reminder: do not use the fan in the sun or ventilated to dry it is not easy to break, electrical equipment afraid of moisture. If you do not know how to make your own, it is recommended that you still buy it, do not fool around to avoid danger!

Homemade humidifier method three

Required materials: ultrasonic atomizer and supporting; power supply fan; fan protection mesh (optional); plastic box for water; plastic sheet (to do the lid); for the water level sensing trip switch; 3R33 * 1; 33uF capacitor * 2; 200K potentiometer * 1; plugs, sockets, a set of (what can be).

Steps: Cut off four flat pieces of foam block. Apply white latex (do not use 502 ah, will dissolve the foam).

Press around the box (I used a ballpoint pen to draw a line, to prevent paste crooked). In the metal part of the switch on top of the welded straighten the paper clip. Cut a piece of plastic first, just enough to cover the plastic box shell. Then dig a round hole just enough to hold the fan to the plastic piece without it falling in. You'll also have to make a shroud to keep water from wetting the fan. Connect the wires to the switch, glue the regulator part next to the fan, and glue the tube for the wind direction.

These are just a few ways to make your own humidifier, isn't it super easy? If you have also learned it, you may want to try it.