One, we must do a good job of preparation before commissioning, because the Wuxi combustible gas alarm manufacturer controller line is more complex, in the case of wiring error occurs, commissioning should be in the case of checking the connection of the line, otherwise it will cause serious consequences. Insulation resistance is less than 20MΩ cause, on the one hand, the construction should be operated in accordance with the regulations, on the other hand, it may be the wire is scratched, etc., so it should take appropriate measures to deal with.
Two, Wuxi combustible gas alarm manufacturer controller commissioning methods and requirements.
Three, Wuxi combustible gas alarm manufacturers commissioning methods and requirements.
Four, emergency shut-off valve debugging methods and requirements.
Fifth, the system of standby power commissioning requirements. Whether the backup power is reliable is directly related to the reliability of the entire system. Emphasize that the capacity of the backup power supply should be consistent with the design capacity, if the backup power supply capacity is not enough or low voltage, the whole system can not work properly.
Sixth, sound and light alarm and exhaust device commissioning methods and requirements.
VII, the whole system commissioning normal, should be run continuously after 120H without failure, and then fill in the commissioning report according to the provisions of these regulations, before the acceptance of the project.