Rubber is sliced by a rubber mixer first, and then sent to a sol tank to be mixed with gasoline for sol. After emulsification and preparation, the sol is pumped into the latex intermediate tank. The rubber solution dissolved in gasoline is fed from the top of the distillation tower, heated and distilled by steam, so that the light gasoline is heated into gas phase, and the gasoline gas is mixed with cold water in the oil-gas cooler for cooling. The oil-water mixture enters the oil-water separator, and the oil-water is stratified. Recovering the upper gasoline, pumping the lower water into the cooling tower for cooling, and cooling the gas gasoline in the distillation tower after cooling; The latex in the distillation column kettle is sent to the latex mixing barrel for stirring and modulation according to its own pressure, and then the latex is separated from the glove raw material by a centrifuge, and then colored and filtered for later use.
Wash the glove model with acid, alkali and water, soak the cleaned model in hot water, heat it, then soak it in coagulant, and soak it after drying. After dipping, it is sent to an oven for preliminary drying, added with fiber inner sleeve, washed with hot water, and then sent to the oven for vulcanization, drying and molding. After the gloves are demoulded, they are inflated for inspection, set at low temperature, dried at medium temperature, washed with water, dehydrated and dried, and then packaged and sent to the finished product warehouse.