Imaging equipment to install the basic conditions are as follows:
1, try to choose a dust-free environment, to prevent the instrument rails, lenses, etc. stained with dust and debris, will be on the accuracy of the imaging caused by serious impact. Regularly clean the instrument.
2, reduce oil, prevent the guide rail, lens, scale and plane glass, etc. stained with oil, otherwise it will affect the normal use of the instrument.
3, the location must be as far away as possible from the source of vibration, prevent placed above the second floor to prevent vibration affects the accuracy.
4, to prevent direct sunlight, compartment adiabatic as far as possible using RC results.
5, the air-conditioner outlet to prevent direct blowing to the machine, with automatic temperature control system. Temperature 20 ± 2 ℃, humidity scale 30% -70%.
Maintenance of imaging equipment:
1, the instrument should be placed in a clean and dry room (room temperature 20 ℃ ± 5 ℃, humidity below 60%), to prevent the optical parts of the exterior of the stained, rusted metal parts, dust and debris fall into the motion guide, affecting the performance of the instrument.
2, the end of the instrument, the work surface should always wipe clean, and then cover the dust cover.
3, the instrument's transmission mechanism and the movement of the guide rail should be on a regular basis on the smooth oil, so that the smooth movement of the mechanism, adhere to the good state of use.
4, the bench glass and paint appearance is dirty, can use neutral detergent and water to wipe clean. Never use organic solvents to wipe the paint appearance, otherwise, will make the paint appearance lose luster.
5, the instrument fine parts, such as the image system, table, optical ruler and Z-axis drive mechanism need to be fine tuning, all adjusting screws and fastening screws have been fixed, the customer should not disassemble, if there is a problem, please notify the manufacturer to deal with.
6. The software has accurately compensated for the errors of the table and the optical ruler, so please do not change it yourself. Otherwise, it will produce wrong measurement results.
7, the instrument all electrical connectors, general do not unplug, such as has been unplugged, it is necessary to correctly inserted according to the sign back and tighten the screws. Incorrect plugging, light impact on the function of the instrument, or may damage the system.