Plastic storage tanks in the installation and use of the following things need to pay attention to:
1, plastic storage tank manufacturers tip, and plastic storage tanks connected to the lower part of the joints or flange pipe should be perpendicular to the barrel wall, it is best to use a soft connection, so as to avoid filling the liquid, the barrel wall unevenly expanding up and down the wall resulting in damage to the joints connected to lead to leakage, and serious damage to the joints and the barrel body.
2, the liquid inlet port from the bottom of the tank is high, the liquid inlet port should be bent to the tank wall to let the liquid into the tank wall down, reduce the impact on the bottom.
3, plastic storage tanks have been with an integral one-time molding of the strengthening ring, if necessary, can be used to limit the expansion and deformation of the barrel metal reinforcing sleeve to avoid the bottom of the expansion.
4, in the drum on the installation of mixers and other heavy ancillary equipment, or people have to work on the roof of the tank and the roof of the tank can not withstand the weight of the person, please make another rack or ladder, and pay attention to the safety of operation.
5, plastic tank manufacturers suggest that, in the case of liquid level can not be controlled, should be equipped with an overflow port to prevent the liquid from overflowing from the manhole, resulting in unnecessary injuries.
6, into the liquid, liquid discharge flow rate is large, should be installed with the appropriate flow rate of the exhaust pipe.
7, the installation of plastic tank foundation requirements level and can withstand the corresponding pressure, such as steel structure, the gap can not be too large, and should be laid on the top of the wood or iron plate.
8, plastic storage tanks in the storage of chemicals, the site should be surrounded by a good drainage trench and dilution device.
9, due to plastic tanks in the molding of the inevitable bottom to the tank protrudes to form a crown, so the foundation should be made and the bottom of the shape of the crown similar to the shape of the crown, in the level of the foundation does not need to be paved with sand and the bottom of the plastic tanks corresponding to the shape of the crown, in the open-air use of the type of appropriate to avoid direct sunlight, to prolong the service life.
10, large size plastic tanks should pay attention to safety during installation, try to use the crane.
11, plastic tanks installed, before use should be docked to check the sealing performance of the interface, can add liquid over the interface to observe whether the leakage. Plastic tanks containing chemical liquids, it is best to use water to test the leakage, in order to prevent massive losses.