Should keep the ultrasonic cleaning equipment workplace ventilation, dry, clean, conducive to the long-term efficient operation of the equipment and optimize the working environment conditions. In particular, attention should be paid to the electrical control box and ultrasonic cleaning equipment vents must be away from water vapor, corrosive gases, dust, and should be regularly cleaned with compressed air attached to the dust.
Two, pay attention to regular cleaning of equipment and lubrication maintenance
Easy-to-operate ultrasonic cleaning equipment cleaning fluid is too dirty should be dealt with in a timely manner, and regularly clean up the cleaning tank, reservoir tank dirt, because keep the cleaning tank and the appearance of the clean tank can improve the durability of the cleaning tank. And if the ultrasonic cleaning equipment with a transmission mechanism, should be required to regularly add grease, oil and other lubricants as well as regular replacement of gear oil reducer to ensure that the movement of parts in good lubrication conditions.
Three, pay attention to regular testing
Service quality of ultrasonic cleaning equipment manufacturers to ensure the accuracy of the equipment, should be regularly testing the insulation of the equipment and regularly check the aging of the electrical components, such as checking the grounding wire to ensure that the equipment is well grounded in this project must be carried out by a professional experience of the electrician. Should also regularly test the power supply and confirm compliance with the equipment's power supply voltage requirements, to avoid too high or too low in the unstable power supply long-term work; and note that for equipment with a filtering device, should be regularly replaced filter cartridges.
The above is the maintenance of ultrasonic cleaning equipment need to pay attention to several aspects, in addition to the failure of the problem should be timely to find the cause and make the correct treatment and response. For example, the occurrence of the fuse burned out and no blackening of the glass tube should check the power supply voltage, may be too high power supply voltage or load caused by instantaneous changes, should be replaced with the same specifications of the fuse or a slightly larger fuse; but if you can not find out the reason, then you should contact the manufacturer's professionals in a timely manner for maintenance.