The manufacture and installation of carbon steel water tank is not affected by civil construction, without welding equipment, and its surface is treated with hot zinc corrosion protection, which is beautiful and durable, prevents secondary pollution of water quality, is beneficial to human health, and meets the requirements of standardization, serialization and industrialization of building products.
The water tank is made of Q235 steel plate and stamped with 1000× 1000 and 1000×500 standard blocks. Peripheral drilling, hot dip galvanizing and on-site installation. When assembling, the standard block is connected with non-toxic rubber pad and bolt.
The water tank is suitable for storage and regulation of building water supply, expansion and condensation water tank of heating system, and temporary water storage water tank for building construction, geological survey, industry and national defense engineering.
The water storage capacity varies from 1.0 cubic meter to 1000 cubic meter, and the height can reach 5 meters.
The diameters and positions of water inlet pipe, water outlet pipe and overflow pipe of water tank are determined by design; There should be no less than 7000mm of channels around the water tank, and the bottom and accessories of the water tank should be hot galvanized.
Water filling test: After the water tank is assembled, close the water outlet pipe and drain pipe, open the water inlet pipe, and check the water until it is full. 2-3 hours without water seepage is qualified.
1m 3.0mm at the bottom and side of the high water tank.
The bottom of the 2-meter-high water tank is 3.0 mm on the side.
The bottom of the 3-meter-high water tank has a 3.0-mm edge.
The bottom of the 4-meter-high water tank is 5.0mm on the side and 3.0mm on the second, third and fourth floors.
Water tank cleaning
1. Close the water inlet valve, open the drain plug (or valve), and drain the remaining water in the water tank;
2. Enter the water tank through the ladder;
3. Clean the periphery and bottom of the water tank with a clean mop or rag. If the scale at the bottom is serious, you can scrub it with a soft towel and detergent;
4, open the water inlet valve, put in the right amount of water to wash the barrel wall and bottom, so that the sewage is discharged from the sewage outlet, and it can be repeated many times when necessary until it is satisfactory;
5. Tighten the drain plug, open the inlet valve and refill the water tank. The cleaning work is over.